submitted 7 months ago by wccrawford@lemmy.world to c/3dprinting@lemmy.ml

4 comments fedilink hide all child comments

On the bottom of my prints, there's an area of underextrusion and I can't figure out what's causing it.

I first noticed it when I switched back to a textured PEI bed while trying to print ASA. It's on 20x20mm squares, and it's on the test print for setting up pressure advance... But only on the left-most object.

It's the same even if I add 2 lines of skirt or not. (In addition to my KAMP Voron purge.)

It happens everywhere on the bed that I've tested. It happens to PLA, but it harder to see. For ASA, it's very obvious. For PLA, it's almost as smooth as the rest of the surface, but it's there if you know what you're looking for.

I've only been printing PLA for quite a while now, so I don't know when this started.

I've got an LDO Voron 2.4 with Tap, KAMP, Revo hot end. I've calibrated pressure advanced and changed the value, and I've tried different z offsets with the textured bed, which doesn't change it. (But does change how good the rest of the bottom surface looks.)

Anyone got any ideas?

https://imgur.com/a/ggaZDMY

you are viewing a single comment's thread
view the rest of the comments

[-] wccrawford@lemmy.world 2 points 7 months ago

I posted in another community on Lemmy and got some suggestions, but the only that that's make a different so far is printing a lot slower. That decreased the underextrusion area to about half, but it's still there and very obvious on ASA.

I'm leaning towards a bad extruder (or at least bad gears), but they're BMG and I don't feel like they've had that much usage yet. I might take the opportunity to replace it with a Galileo 2 and see what happens.

If I end up figuring this out, I'll come back and reply again.

this post was submitted on 06 Apr 2024

11 points (100.0% liked)

3D Printing

4392 readers

3 users here now

For everyhting 3D printing related.

Please be excellent to each other :)

Icon by Freepik, Banner photo by Thiago Medeiros Araujo

founded 4 years ago

MODERATORS

3dnudel@lemmy.ml