How can I figure out which phases in a BLDC motor to power without knowing how its wound? (programming.dev)

submitted 1 month ago by iliketurtiles@programming.dev to c/askelectronics@discuss.tchncs.de

0 comments fedilink hide all child comments

I'm making a driver for a small 15V, hall sensored, 9-slot BLDC motor I got off of AliExpress. It has u,v,w inputs. Three hall outputs and Vcc, Gnd for them. No datasheet :)

I understand the working principle: I'll have to use the hall sensors to figure out the location of the rotor, then power the appropriate windings.

Trouble is, I don't know how the windings for the three phases are arranged within the motor. So I don't know which pin to give power to, because I don't know which windings within the motor will then be powered.

How can I figure out where the windings are for each phase?

I'm guessing I've got to manually spin the motor and do some detective work with back-emf measurements and hall sensor outputs to figure this out?

no comments (yet)

sorted by: hot top controversial new old

there doesn't seem to be anything here

this post was submitted on 12 Mar 2025

1 points (100.0% liked)

Ask Electronics

3606 readers

42 users here now

For questions about component-level electronic circuits, tools and equipment.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: Be safe.

founded 2 years ago

MODERATORS

DavideAndrea@discuss.tchncs.de

linker3000@discuss.tchncs.de