submitted 2 months ago by Practical_Plan_2560@lemmy.ml to c/homeassistant@lemmy.world

32 comments fedilink hide all child comments

Anyone try to build a bed occupancy sensor integrated with Home Assistant? I've looked into load sensors but all of them seem to have pretty small weight limits (low enough to where I don't think it would even support the empty bed).

What devices/sensors have you used for this? And what does your setup look like?

you are viewing a single comment's thread
view the rest of the comments

[-] BlueEther@no.lastname.nz 1 points 2 months ago

How about mm radar?

I grabbed a couple of Ali last month to use for lighting sensors for the hall and toilet, not set up yet

this post was submitted on 17 Mar 2025

11 points (92.3% liked)

homeassistant

14804 readers

1 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @GreatAlbatross@feddit.uk

founded 2 years ago

MODERATORS

GreatAlbatross@feddit.uk

greatalbatross@lemmy.world