874
Peak homelabbing
(lemmy.world)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 06 Aug 2025
874 points (99.4% liked)
Programmer Humor
25671 readers
2602 users here now
Welcome to Programmer Humor!
This is a place where you can post jokes, memes, humor, etc. related to programming!
For sharing awful code theres also Programming Horror.
Rules
- Keep content in english
- No advertisements
- Posts must be related to programming or programmer topics
founded 2 years ago
MODERATORS
Take out the lid-close sensor and use it in a side project that requires a proximity sensor.
isn't it Hall sensor?
I might/might not be one.
But it definitely is a proximity sensor. Unless yours is an Apple device, in which case, it might be an angle sensor.
The term "Hall sensor" would refer to the tech used in it, whereas the term "proximity sensor" refers to its function.
It could be using any other proximity sensing technique too and it would still be a proximity sensor.
technically yes. usually proximity sensor is used to mean IR or sonic sensors and I read in that sense.
I see.
I used "proximity sensor" because I didn't know what these sensors use and didn't want to worry about it while writing that comment.
If the Dexter actor is near it, the screen goes off
On thinkpads it is, there is a magnet on the bottom.
I had a dell latitude for my first server. even when I removed the magnets, some how it still would detect that the kid was closed and turn off. I tried everything I could think of and more, without any luck. the solution? I removed the display entirely so it couldn't be closed and only used it via ssh or a VGA monitor if I really needed it.
I have an older ASUS ROG laptop in which the sensor is a separate PCB (less than a thumb in size) connected using a few IDC pins.
It could simply be taken off and I haven't even opened the monitor frame yet.