28
What 3D Printer should I buy as my first?
(piefed.social)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 24 Feb 2026
28 points (96.7% liked)
3D Printing
5506 readers
1 users here now
For everyhting 3D printing related.
Please be excellent to each other :)
Icon by Freepik, Banner photo by Thiago Medeiros Araujo
founded 5 years ago
MODERATORS
You can put custom firmware on the x1c and use whatever the hell you want. Make sure you put it somewhere you can vent outside, so not in the living room.
bambu x1c ?
I don't want to support companies that lock down their firmware. The more Open-Source the better.
The are also printers that are inspired by the voron project, while not fully being a voron, but more pre-assembled. I think sovol has some, and formbot has the troodon series, including a smaller 250mm version.
I haven't used either, but it might be worth looking into. I did but a voron kit by formbot and honestly that was great. Firmware is just klipper, so fully open source, of course.
Sovol sv08 is basically a prebuilt voron
They aren't vorons then. There are printers, including some that I listed, that are very closer to this conceptually, but they aren't allowed to be called vorons (and you won't get an official serial number for them).
One core point of a voron is the fact that it's built, from scratch, by you. A pre-assembled printer can never be a Voron.
Note that anyone is free to use the parts and designs, that's the point of them being open-source. The Voron name is intentionally protected so you can't sell a commercial 3d printer product called Voron.
If you don't want to go down the e.g. "Voron route" nor that I could recommend for the first 3D-Printer, Prusa or partially Sovol Printers would be good. For what I can say Prusa MK4S would be a solid option, although more costly than the Mini.