673
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 22 Dec 2023
673 points (98.7% liked)
Technology
60062 readers
1649 users here now
This is a most excellent place for technology news and articles.
Our Rules
- Follow the lemmy.world rules.
- Only tech related content.
- Be excellent to each another!
- Mod approved content bots can post up to 10 articles per day.
- Threads asking for personal tech support may be deleted.
- Politics threads may be removed.
- No memes allowed as posts, OK to post as comments.
- Only approved bots from the list below, to ask if your bot can be added please contact us.
- Check for duplicates before posting, duplicates may be removed
Approved Bots
founded 2 years ago
MODERATORS
They're not really particularly low power.
Quick search suggests around 8W power consumption with a 2 ohm heater, which at the approximately 4V of a charged Lithium-Ion battery (V=IR, P=VI) checks out to around a 2A draw.
Similar results suggest the batteries inside are in the neighbourhood of 0.75Ah (3.7V nominal) = 2.8Wh. I don't know how much of that capacity actually gets used during the "lifespan" of the vape, but I'd guess half would be a good estimate. In any case, probably safe to assume you need to pack around 2Wh in at minimum.
A Lithium AA battery (Li-FeS2 chemistry) gives you 3.4Ah @ 1.5V = 5.1Wh, but has a maximum discharge current of 2.5A (only 3.8W). The AAA is only 1.2Ah with 1.5A discharge, but two of them would give you 3.6Wh and 4.5W, closer to the target but still under.
You could probably arrange this in some sort of configuration whereby the batteries charge a capacitor and that runs the heater, at those kind of numbers it'd need to be at most a 2 seconds off for 1 second on deal, but that honestly seems like it should be fine for, y'know, vaping. Might just need to have an on/off switch to avoid draining the batteries when you're not using it.
But I guess we're at the point where manufacturing Li-Po cells happens in such vast quantities that the extra electronics to charge a capacitor from a 1.5V battery probably cost more.
Not that it really matters for the topic of disposables, but enthusiasts would often run two cells in series with sub-ohm coils. Or two cells in parallel to be able to handle the draw of going down to 0.1. Give that to ELI.