89
I'm new to 3D printing and CAD, it's not the best looking, I was going for fast printing. I borrowed a couple of files from the internet to get the dimensions of the charger and the thunderbolt.
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 03 Feb 2024
89 points (98.9% liked)
3DPrinting
15599 readers
134 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: !functionalprint@kbin.social or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 1 year ago
MODERATORS
You might want to print it laying down, so the layer lines aren't at the breaking to get stuck inside your laptop , but nice altogether! My charger has long died, and I'm using a USB c to mag charger that mostly works (and still disconnects if you look at it funny)
Sounds like a good idea, thanks! I was planning on printing a new one because the thunderbolt plug is a little long, I'll see how it goes lying down.
I really dislike these magnetic chargers, it has been bothering me since I bought this laptop in 2015, it's so unreliable.
Lying down would be hard to print due to the hollow cavity where the charger goes. You could split it into two separate sections and then glue it together. Easier solution is to model or drill a 2mm hole through the part and glue a piece of filament in place to give it some strength.
Tree supports and careful use of an exacto knife could also make it work. Post processing can be a bit much sometimes, but it doesn't have to be the enemy either.
~~Flip it before printing.~~ Nvm, I see the problem
The right angle MagSafe chargers are much better if you can find one. They have less leverage in the magnets, plus the cord can come out the back of the laptop, or along side the side, which usually fits better in my use cases.