Does anyone have a trick for this problem with self-driving screws? (lemmy.ca)

submitted 6 months ago* (last edited 6 months ago) by NataliePortland@lemmy.ca to c/woodworking@lemmy.ca

13 comments fedilink hide all child comments

Situation: using a screw gun to drive in the self-driving screws (the star shaped ones) horizontally, and sometimes at a difficult angle above my head. Hard to get good leverage like that. The driver starts spinning the screw but it doesn’t catch right away and then the screw jumps out and falls on the ground.

Has this happened to you? Is there a trick for that?

you are viewing a single comment's thread
view the rest of the comments

[-] IMALlama@lemmy.world 2 points 6 months ago

Completely agree. It's also worth saying that worn Phillips bits don't perform as well as ones with less wear. If OP is using a cordless drill, use the clutch to avoid the bit caming out.

this post was submitted on 28 Jul 2024

19 points (91.3% liked)

Woodworking

6372 readers

107 users here now

A handmade home for woodworkers and admirers of woodworkers. Our community icon is submitted by @1985MustangCobra@lemmy.ca whose father was inspired to start woodworking by Norm and the New Yankee Workshop.

founded 2 years ago

MODERATORS

NataliePortland@lemmy.ca