196
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 28 Sep 2024
196 points (100.0% liked)
Technology
37800 readers
165 users here now
A nice place to discuss rumors, happenings, innovations, and challenges in the technology sphere. We also welcome discussions on the intersections of technology and society. If it’s technological news or discussion of technology, it probably belongs here.
Remember the overriding ethos on Beehaw: Be(e) Nice. Each user you encounter here is a person, and should be treated with kindness (even if they’re wrong, or use a Linux distro you don’t like). Personal attacks will not be tolerated.
Subcommunities on Beehaw:
This community's icon was made by Aaron Schneider, under the CC-BY-NC-SA 4.0 license.
founded 2 years ago
MODERATORS
Huh? ROCm is not working for me at all so far. I've tried to get it to work with Koboldcpp (which I have to build in a distrobox for it to even run, but then it only runs in software / cpu mode), tried LM Studio (which is easy to install, but again, no ROCm / gpu support detected), and I tried Krita's diffusion implementation (again, only cpu working). This and the fact that I can't get Mullvad to run are my biggest pet peeves so far.
Ironically, I decided to try it, despite my already existing skepticism beforehand, because TimeShift managed to break my post update broken system even further to the point where I couldn't figure out if it is even salvageable (definitely not for me though). I can't go back to Windows but I also still have not really found a good distro for me yet.
Hmm, I'll have to double-check it on my build. Pretty sure it was working, but it's possible I was only getting OpenCL or Vulkan acceleration. Out of curiosity, what's your GPU model? I think only the 7900XT[X] is officially supported for ROCm.
RX 6650 XT. And no, all RDNA 2 cards support ROCm. I literally had it running on my previous distro. Was a pain to install with all its dependencies and building the tools properly, since you often had to specify the model, but it was doable. On Bazzite it just seems impossible for me.