We are shutting down Ondsel | Ondsel (ondsel.com)

submitted 1 week ago by Harimau@lemmy.world to c/freecad@lemmy.ml

7 comments fedilink hide all child comments

It was a pleasure using it. I wanted to switch from Fusion to Ondsel and tried to learn it as an alternative.

Did you use Ondsel?

you are viewing a single comment's thread
view the rest of the comments

[-] WbrJr@lemmy.ml 7 points 1 week ago

I reaaaly hoped they would have survived longer. I used it a few times and its a huge improvement to fc, and as far as I know the team contributed quite a lot to essential improvements to get fc to v1.0 Fc is still a difficult software to use, and I wished ondsel could continue to improve it in the correct direction. But well, maybe it will get better soon. I'm thankful for their work either way

[-] Marvelicious@fedia.io 2 points 1 week ago

I had tried FC a few times previously, and wasn't able to make it work for me, but I'm actively using the newest release candidate now. I think it's finally over the hump where a lot more people are going to start adopting it. That should fuel continued development.

this post was submitted on 06 Nov 2024

38 points (97.5% liked)

FreeCAD

856 readers

3 users here now

Your own 3D parametric modeler.

www.freecadweb.org

FreeCAD is an open-source parametric 3D modeler made primarily to design real-life objects of any size. Parametric modeling allows you to easily modify your design by going back into your model history and changing its parameters.

founded 2 years ago

MODERATORS

zksmk@slrpnk.net