Old saw restoration: how much bending & pitting is too much? (media.piefed.social)

submitted 1 week ago by pageflight@piefed.social to c/woodworking@lemmy.ca

2 comments fedilink hide all child comments

The left saw has two kinks, but most of the rust is sanding off pretty well with 220 grit. The right one has a slight bend but no sharp kinks, though it has a fair amount of pitting that's deeper than sandpaper is taking off. I'll probably continue to restore the right one, but curious if folks think they wouldn't be functional.

top 2 comments

sorted by: hot top controversial new old

[-] Buffalobuffalo@lemmy.dbzer0.com 2 points 3 days ago* (last edited 3 days ago)

Pretty personal problem i guess. Not sure any kinks would be acceptable for a cut with any close tolerance. Rough cutting would probably be fine. Working on the 'good' portion would avoid the issues. Would cutting the blade shorter and cleaning the edge make sense, reducing the effective length?

[-] usualsuspect191@lemmy.ca 4 points 1 week ago

How do they cut? I'd personally start with filing and setting the teeth and straightening, then if they work worry about getting them looking nice.

this post was submitted on 15 Dec 2025

36 points (100.0% liked)

Woodworking

8050 readers

2 users here now

A handmade home for woodworkers and admirers of woodworkers. Our community icon is submitted by @1985MustangCobra@lemmy.ca whose father was inspired to start woodworking by Norm and the New Yankee Workshop.

founded 2 years ago

MODERATORS

NataliePortland@lemmy.ca

captain_aggravated@sh.itjust.works