Yeah, that's normal. That's the seam -- where each layer starts/stops. Yours don't look any worse than mine.

Sometimes you can tweak settings to reduce them a bit, but the only way to avoid them completely is to print in spiral/vase mode (which is very limiting: 1 contiguous perimeter, no infill).

More importantly: You can control where they appear on the part! Your slicer may have settings like 'nearest' , 'random', 'aligned', 'rear', or may have a way to paint on the part in the UI where the seams should be. Seams are clearly visible when they're in the middle of an otherwise-smooth expanse like the side of your boat there, but are barely noticeable if you put them on a corner.

As the other use said, this is the Z seam and is pretty normal. If you look at the preview in your slicer, you'll be able to see where they're oriented. One trick is to rotate the part in the slicer so that the seam gets put in a hidden area or on a corner. In Cura, the Z seam will be the white dots on the print in the preview window and the default setting puts them closest to the back corner of the bed.

Once you get more experience and comfortability, you can mess around with these settings in Cura (like coasting, retractions, etc) or setup something like Klipper with Input Shaping.

Well, hello fellow X2 owner. I've had mine for almost 2 years. Still tweaking settings, but I just swapped it over to klipper about 3 months ago. Still not going too fast with outer perimeters running 40mm/s. Inner perimeters at 80-90mm/s. Travel at 200mm/s, supports at 150mm/s. Still have a slight stringing issue with pla with small detail layers. But I'll get you a picture later today of how my seams show up.

But yes, you can assign the position of your seams in most slicers. Basic settings are random, aligned, and back. (Most of the time these are in relation to print bed front/back, not object, so rotating the object can effectively 'move' the seam)

Also, most slicers have an option to paint on the seam.