6
Installing a glass bed on an Ender 3 S1 Pro (lemmings.world)
submitted 1 year ago* (last edited 1 year ago) by moody@lemmings.world to c/3dprinting@lemmy.world
3 comments fedilink hide all child comments

I just got a glass build plate for my S1 Pro, and I'm not sure of the best way to use it. The bed has two screws at the back that stick up a bit past the magnetic sheet and the PEI build plate has two notches to accommodate them, which helps line up the plate. The glass build plate doesn't have any notches, so it can't go flush all the way to the back.

The glass plate is sized the same as the bed, but it can't fit on the bed without hanging off the front of it. Is this normal?

Edit: So the screws on the bed are literally just for the alignment of the magnetic PEI plate. They can be taken out without issue. I tried looking up videos before I posted, and none of them have the same bed as mine, they all seem to have a full-surface magnetic sheet and a full-surface PEI plate.

top 3 comments
sorted by: hot top controversial new old
[-] FuglyDuck@lemmy.world 1 points 1 year ago* (last edited 1 year ago)

measure how thick the whole thing is, you might be able to find swiss clips that will fit over it and hold it in place. Then, remove the screws so it fits in place.

with a 1/8" glass bed, I had four- two on the front and back. I found the sides brushed against the upgrights as it moved in y axis. (your set up may vary,)

[-] moody@lemmings.world 1 points 1 year ago

Are these screws not important?

[-] FuglyDuck@lemmy.world 1 points 1 year ago

Are they the bed adjustment screws? Sorry trying to remind myself with pictures on the internet and I’m not seeing where. Can you get a quick picture?

In any case: The bed adjustment screws should be flush with the aluminum plate and unseen/felt under the magnetic sheet. There should also be the cable with heated bed wires going to a stress relief thingy, that should also be flush with the print area/ out of the way.

Beyond that, I’m pretty sure it can all just get removed. Beds don’t move all that much so if the only purpose is to align it… definitely okay. (The clips or magnetic sheet are sufficient. As long as they don’t get bumped off and go flying…)

this post was submitted on 22 Sep 2023
6 points (100.0% liked)

3DPrinting

15666 readers
80 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: !functionalprint@kbin.social or !functionalprint@fedia.io

There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml

Rules

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago
MODERATORS
andypiper@lemmy.world
henry_rowengartner@lemmy.world
j4k3@lemmy.world
GrayBackgroundMusic@lemm.ee