363
Only Sensor (5, 4, 8-AQ, and 2-TH): The only DIY home automation sensor you'll ever need
(lemmy-ui.nowsci.com:33443)
Hey all,
A couple of weeks ago I posted my 3D printable pegboard organizers, and today I’m releasing the Only Sensor line of home automation sensors.
Fully free and open, complete with wiring diagrams, cases, component bill of materials, and instructions for assembly.
You source and build them yourself, with acquisition costs ranging from $2-$35 to build, and options for:
- mmWave presence
- PIR motion detection
- Temperature
- Humidity
- LUX
- PM <10µm AQI
- PM <2.5µm AQI
- PM <1µm AQI
- NOX
- VOC
All integrate with Home Assistant via ESPHome.
All the details can be found at: https://nowsci.com/only-sensor/
Those dht11 sensors are garbage tho. Best case they are wildly off on their humidity sensor. Worst case they keep breaking and shows nonsense readings. I would recommend bme280 sensor instead. If you read about them you might see people complain that they are reading too high temperatures, but in my experience its because they are misconfigured. Default settings have a very high sampling rate of multiple samples per second that heats up the sensor a tiny bit giving you the offset. Lowering the sampling rate or turn the sensor off completely in between readings gives really precise measurements on both temperatures and humidity.
+1 on BME280 vs the DHT. I don't know why the DHT are so expensive, they're pretty bad.
Yea I've considered recommending thr DHT22 instead, but I was trying to keep costs as low as possible, and honestly I've had pretty good results thus far (calibrating with other systems, anyway).
Bme280 is actually just as cheap if not cheaper than the dht sensors. But its a fair point trying to keep the cost down. I definitely like that philosophy, but if the quality suffers too much it's just not worth the trouble. Keep up the good work. 😎
Oh good to know, will investigate!