How can I saw a board into thin sheets? (feddit.org)

submitted 1 week ago by alleycat@feddit.org to c/woodworking@lemmy.ca

13 comments fedilink hide all child comments

For a small musical instrument I need a thin sheet of spruce (1.5mm). Normally I'd just buy a guitar or lute top, but for this one I need the highest quality I can get, with very narrow rings. So my idea is to saw down a blank for a violin top (25mm at its thickest point). I need to do this with as little waste as possible, because a good spruce top can cost 100-300€.

Is there a way I can do this with hand tools?

you are viewing a single comment's thread
view the rest of the comments

[-] gloktawasright@lemm.ee 3 points 1 week ago

I think you could do this with a pull cut plane after you cut to close to the correct thickness with a hand saw. A pull cut plane will prevent the thin sheet from buckling as you try to thickness it, just have to get clever about anchoring it. You could glue a board to the back and then hook it on a table using that board, plane it until you’re satisfied, then cut the board off.

this post was submitted on 21 Mar 2025

28 points (100.0% liked)

Woodworking

7080 readers

7 users here now

A handmade home for woodworkers and admirers of woodworkers. Our community icon is submitted by @1985MustangCobra@lemmy.ca whose father was inspired to start woodworking by Norm and the New Yankee Workshop.

founded 2 years ago

MODERATORS

NataliePortland@lemmy.ca