I'm slapping together a night stand for my cousin out of crap I have lying around the shop, and I'm using the project as an excuse to try out some stuff.
Carcass is "hardwood" mystery meat 7-ply from Lowe's. Joinery is all dovetails; lower shelf and mid frame are sliding dovetails, upper frame is half-blinds. I did that to see if I could. Answer: Barely. The sliding dovetails were fine but the half-blinds wanted to blow the plywood apart.
Face frame is rift sawn traumatized pine. That's what I managed to salvage from a damaged section of 8:4, and judging by the growth rings that tree had been through at least one divorce. The curve on the bottom I laid out with a bowed spline. First time I've actually done that. It's attached to the carcass Norm style, with Tite-bond and #10 biscuits.
Tomorrow I'll build the drawer.
Dry fit of the drawer:
This is actually my first proper rabbeted drawer front. Amazing how much of a pain in the ass that 3/8" gap is. I think I'm going to make the handle.