5
Cable Clip For 3M Comand Tab by KakeruNekobeya
(www.thingiverse.com)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 19 Aug 2023
5 points (100.0% liked)
Functional 3D Printing
3 readers
1 users here now
Welcome fellow prototypers! This communities' purpose is to help others and share functional 3D Printing related information. While other 3D Printing Communities are a good resource, sometimes too many help posts get buried under memes and fluff. This will remain technically focused and keep the fluff removed. Please help your fellow 3D Printer hobbyists as much as you can with their issues! and showcase your functional prints and how you use or created them.
founded 1 year ago
Might make more sense to print it right side down, so the layer lines go along the clips instead of across them.
Would be a pain in the ass for support building, but maybe print it as just one clip instead of two, and print two of them with a spacer to cover the command strip? Or maybe just a smaller one clip part and cut the command strip?