I am using an Ender 3 Pro v2, and I have followed multiple guides (they all say the same things) for setting up a print to prevent stringing. I’ve also switched between two filaments (Creality and Amolen) and the stringing doesn’t change at all. I have noticed that when heating up the horned, the filament just oozes out like ectoplasm even before the print starts.

I have never had this problem before, and could use some human advice.

I have upgraded/replaced the following parts in the past:

1. Bowden Tubes
2. Printer Nozzles
3. Dual Gear Extruder
4. Heater Block
5. Heater Cartridge
6. Thermistor Temp Sensor

My Tweaked Settings: