20
Stringing/Oozing Problem
(lemmy.ml)
I am using an Ender 3 Pro v2, and I have followed multiple guides (they all say the same things) for setting up a print to prevent stringing. I’ve also switched between two filaments (Creality and Amolen) and the stringing doesn’t change at all. I have noticed that when heating up the horned, the filament just oozes out like ectoplasm even before the print starts.
I have never had this problem before, and could use some human advice.
I have upgraded/replaced the following parts in the past:
- Bowden Tubes
- Printer Nozzles
- Dual Gear Extruder
- Heater Block
- Heater Cartridge
- Thermistor Temp Sensor
My Tweaked Settings:
Since my oven can only go as low as 75°C, I ordered a filament dryer. 😠
~Stupid oven.~
Anytime I take a spool off the printer I put it back in the filament dryer. Once it's done it goes in a sealed bag with dessicant. This keeps the filament dry and prevents stringing.
Also don't use your food oven for plastic anyway.
Would a plain old ziplock bag with the air vacuumed out be sufficient?
😅 um.. 😅 🥺
Yes that's what I use. Any 1 gallon Ziploc or other brand is fine.
I mean if you have a heated bed that works.