Pipewire/Wireplumber set volume based on node name (lemmy.world)

submitted 1 month ago by Zangoose@lemmy.world to c/linux@programming.dev

5 comments fedilink hide all child comments

I have a virtual source and a virtual sink which I'm using to forward audio to/from chat apps (Matrix, Discord, Zoom, etc.) so I can control the mic/output volume independently of everything else on my system. I have them setup and working fine using pipewire.conf.d files. The problem is that using wpctl to change volume requires having an ID, but those aren't static. Normally the solution would be to use @DEFAULT_AUDIO_SOURCE@ (or sink), but that wouldn't work in this case. Is there a way to adjust volume/toggle mute without having the ID? Or alternatively, is there a way to get the ID for a specific node name that I can put in a bash script?

If I'm asking this in the wrong place, is there a better place to go?

you are viewing a single comment's thread
view the rest of the comments

[-] domi@lemmy.secnd.me 5 points 1 month ago

I did something similar a while ago but for changing volume on a single application, should work for devices as well though since both are just nodes.

Try this:

#!/bin/sh

node_id=$(pw-dump | jq '.[] | select(.type == "PipeWire:Interface:Node" and .info.props."node.name" == "Virtual-Sink-1") | .id')

echo "Adjusting volume for $node_id"

wpctl set-volume $node_id 10%-

Replace Virtual-Sink-1 with the name of your audio device and 10%- with the operation you want to perform.

[-] Zangoose@lemmy.world 3 points 1 month ago

This works, thanks!

this post was submitted on 15 May 2025

28 points (100.0% liked)

Linux

7983 readers

433 users here now

A community for everything relating to the GNU/Linux operating system

Also check out:

Original icon base courtesy of lewing@isc.tamu.edu and The GIMP

founded 2 years ago

MODERATORS

Ategon@programming.dev

anzo@programming.dev

dwraf_of_ignorance@programming.dev