139
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 10 Oct 2025
139 points (99.3% liked)
Asklemmy
50872 readers
585 users here now
A loosely moderated place to ask open-ended questions
Search asklemmy ๐
If your post meets the following criteria, it's welcome here!
- Open-ended question
- Not offensive: at this point, we do not have the bandwidth to moderate overtly political discussions. Assume best intent and be excellent to each other.
- Not regarding using or support for Lemmy: context, see the list of support communities and tools for finding communities below
- Not ad nauseam inducing: please make sure it is a question that would be new to most members
- An actual topic of discussion
Looking for support?
Looking for a community?
- Lemmyverse: community search
- sub.rehab: maps old subreddits to fediverse options, marks official as such
- !lemmy411@lemmy.ca: a community for finding communities
~Icon~ ~by~ ~@Double_A@discuss.tchncs.de~
founded 6 years ago
MODERATORS
The diagrams I've seen show the wave stirrer on the roof. The microwaves I've seen have the ceramic plate on the side where the magnetron is so there's no space for a stirrer.
if the diagram's any good, it should show the wave stirrer in the roof rather than on the ceiling of the food chamber. There's typically a waveguide to take the microwaves from the magnetron to the top of the chamber, then the wave stirrer is at the end of the waveguide to vary the angle that microwaves enter the chamber at. There's usually something to stop food splashing/spraying into that section, though, e.g. an extra few centimetres of waveguide afterwards with a bend in it.