submitted 1 week ago* (last edited 1 week ago) by fujiwood@lemmy.world to c/woodworking@lemmy.ca

9 comments fedilink hide all child comments

Making some bookeneds by hand.

So far I used hand saws to rough cut and rip the board. Then a shooting board to create flat and perpendicular edges.

A saw and chisel to begin the curved edges. A carving knife to get me close and a spoke shave to give it a smoother curve.

Next will be dovetails.

#woodworking #wood #handtools #oc

you are viewing a single comment's thread
view the rest of the comments

[-] clay_pidgin@sh.itjust.works 2 points 1 week ago

Any tips? I'm not sure if mine is set up badly or if I'm just bad at using it. Probably both. It either glides without cutting or it bites hard and gets stuck or takes out a stupid chunk.

[-] fujiwood@lemmy.world 3 points 1 week ago

A few tips.

Make sure sole is flat and smooth.
Flatten the frog so the blade makes full contact.
Make sure the area of the cap that touches the bald is flat.
Start your cut with the blade fully retracted. Then turn your knobs a quarter turn untill you begin to cut.

I'm not sure what the cutting angle should be or if you need a secondary bevel. I will be learning that probably tomorrow when I sharpen mine.

[-] clay_pidgin@sh.itjust.works 2 points 1 week ago

I'll play with it. Thank you very much for the assistance!

this post was submitted on 03 Dec 2025

54 points (100.0% liked)

Woodworking

8039 readers

109 users here now

A handmade home for woodworkers and admirers of woodworkers. Our community icon is submitted by @1985MustangCobra@lemmy.ca whose father was inspired to start woodworking by Norm and the New Yankee Workshop.

founded 2 years ago

MODERATORS

NataliePortland@lemmy.ca

captain_aggravated@sh.itjust.works