101
What 3D printing-related software runs on Linux?
(lemmy.zip)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 19 Dec 2025
101 points (98.1% liked)
Linux
57274 readers
657 users here now
From Wikipedia, the free encyclopedia
Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).
Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.
Rules
- Posts must be relevant to operating systems running the Linux kernel. GNU/Linux or otherwise.
- No misinformation
- No NSFW content
- No hate speech, bigotry, etc
Related Communities
Community icon by Alpár-Etele Méder, licensed under CC BY 3.0
founded 6 years ago
MODERATORS
What do you like about orcaslicer? I've mostly just used Cura because it was the first one I picked up and it seemed to work fine.
Cura was also the first one i used, but it was a creality branded shitshow of a program. So i found orca slightly after that and now use it ever since. I love the inbuilt filament calibration tools and especially, that i can control my printer directly from the slicer, to e. G. stop a job i sent too hastily or something.