39
3d modelling and slicing software for Linux
(lemmy.world)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 30 Aug 2023
39 points (100.0% liked)
Linux
48009 readers
890 users here now
From Wikipedia, the free encyclopedia
Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).
Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.
Rules
- Posts must be relevant to operating systems running the Linux kernel. GNU/Linux or otherwise.
- No misinformation
- No NSFW content
- No hate speech, bigotry, etc
Related Communities
Community icon by Alpár-Etele Méder, licensed under CC BY 3.0
founded 5 years ago
MODERATORS
Thanks! I'll look into Freecad
Be careful, the interface is out of 2008 and many things work differently than F360. Especially assemblies.
Keep at it look up many videos, it is super powerful. Just not as streamlined as F360
I have made a small form factor computer case as well as a flight stick in it. Definitely good software. Hopefully in the next 2-3 years it will get immensly better also because many people are starting to work on it.
Try plasticity, it's a paid OSS but amazing.