16
How do I fix this Prusaslicer output?
(lemmy.ml)
With this particular model, Prusaslicer is very optimistic about bridging and support generation:
- the right side (dark blue) has no support that could help with load-bearing
- the entire layer will be connected to those two lines
- more than 5cm long bridges
I don't think this gcode will successfully print.
How do fix adjust the cura setting to generate a printable output?
The model in question is: https://www.delta-fan.com/Download/3D/BUB0612HJ-00.stp
Use support enforcers
Thanks. Is there also the option to rotate the pattern direction by 90° so it takes the short distances for bridges?
"fill angle" under infill settings.
Fill angle didn't change this as Prusaslicer sees this as a bridge.
https://help.prusa3d.com/article/infill_42#fill-angle
edit: just saw that there is a bridge angle setting that sets a fixed angle for every bridge.