441
What industry secret are you aware of that most people aren't?
(programming.dev)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 24 Jun 2024
441 points (98.0% liked)
Asklemmy
43944 readers
578 users here now
A loosely moderated place to ask open-ended questions
Search asklemmy ๐
If your post meets the following criteria, it's welcome here!
- Open-ended question
- Not offensive: at this point, we do not have the bandwidth to moderate overtly political discussions. Assume best intent and be excellent to each other.
- Not regarding using or support for Lemmy: context, see the list of support communities and tools for finding communities below
- Not ad nauseam inducing: please make sure it is a question that would be new to most members
- An actual topic of discussion
Looking for support?
Looking for a community?
- Lemmyverse: community search
- sub.rehab: maps old subreddits to fediverse options, marks official as such
- !lemmy411@lemmy.ca: a community for finding communities
~Icon~ ~by~ ~@Double_A@discuss.tchncs.de~
founded 5 years ago
MODERATORS
Username checks out! /s
No, they'll be fine. And if they are connected reasonably well, will sound as good as any other speaker cable.
Of course, there are one or two scenarios where that can change, but for most people they aren't applicable.
Powered, as in active? No, those are connected internally. Cabling is then between the internal amp and a preamplifier, which is line level.
I would point you to the overwhelming lack of any reported incidents of speakers or amplifiers catching fire because the wires were too thin. This is simply fiction.
Coat hangers are generally much wider than any speaker wire, and the metal used makes little to no difference to the sound or the load. It is of no importance, you can do this safely.
As I've said, there are a few scenarios where you could run into problems, but these are very much outside of home hifi.