13
Toasted Torture Toaster
(lemmy.snekerpimp.space)
This is a cry for help. I have a Monoprice Voxel which is basically a Flashforge Adventurer 3. Owned for about 3 years now, and still have only a slight idea as to what I am doing. I have been successful with small prints, little thin walled custom functional prints, and they do fine. Trying to print anything longer than 3 hours and I start having issues. I printed a torture toaster and attached is the result. I have never had layer shift like this. Was wondering if anyone out there had any pointers or tips for this printer and pla prints? Are there any other testing prints I can use to help tune and hone in on a perfect print? Good resources for using these testers to tune your prints? Thanks in advance!
+1 to the skipped steps discussion. Those offsets are from the print head somehow getting stuck and not moving when the stepper driver commands a move. Reasons can vary but often they are mechanically related.
One very basic test is to move the head with your hands through its entire travel range on both axes (with motors off ie M84 or printer off) and feel the resistance to motion. Steppers of this size are not particularly powerful; you can overcome their force with your hands.
Another possibility is that the acceleration is set too high: a fast direction change puts a lot of force on the motor. Try setting your acceleration really low, like 100, in the slicer and see if it still behaves that way. If not then there’s your handle on a parameter to tune.
The poor behavior in the toast is probably a different parameter that needs tuning. I suggest getting the layer shift problem fixed before worrying about anything else.