29
Advice for changing break pads
(lemm.ee)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 30 Sep 2024
29 points (93.9% liked)
Mechanic Advice
275 readers
1 users here now
This community is for getting help with vehicle or other mechanical problems.
Remember, there are no stupid questions, we want everyone to feel welcome. If you don't want to answer a question that you think is silly, then just move on and keep it to yourself.
Rules:
- Don't be a dick
That is all.
founded 1 year ago
MODERATORS
I don't know Jack about Kias, but this is how I change my pads.
I use a large C clamp to compress the brake cylinder into the caliper, which releases the pressure on the existing pads and gives room for the new pads going on. I take it slow, and have never had issues using this method
For bound bolts/nuts I use a 50/50 mix of acetone and transmission fluid on any offending parts. I wait a few minutes for it to soak in, and voila! Don't waste time with WD40, go straight to the good stuff
Since you haven't opened anything within the brake fluid system, there's no need to bleed. Except your knuckles. Wear gloves
To push the pistons of the rear brakes back, you probably need a special mechanical device that rotates the piston while simultaneously applying pressure to push it back.
My Transit van will probably be the first vehicle I don't do my own brakes on. I've heard the rear brakes are a chore. Sounds like Kia rear brakes are similarly annoying
I only know from the Kia Picanto and Ford Focus, both about 20 years old. It isn't overcomplicated and the "special" device isn't that expensive, a set that will work on (almost) any car costs about 20 €.