submitted 1 month ago by argueswithidiots@lemmy.world to c/diy@lemmy.world

8 comments fedilink hide all child comments

Trying to get this gate to sit level and swing freely. I used an adjust-a-gate kit. The width is 92", height is 6'. I have used the lightest possible wood, and I can't get this damn thing to hang straight. The turnbuckle that came with it bent straight and came flying out of the holes, so I used a different one I had on hand. Clearly the wheel isn't doing anything except causing the gate to warp since it isn't centered under the weight.

I want to add a diagonal cross brace from the bottom hinge to the top corner, but I'm not sure how exactly to do it with the 3 horizontal boards.

I'm also considered replacing the hinges with 3 extra long strap hinges, one on each horizontal board.

What do you guys think?

Gates

you are viewing a single comment's thread
view the rest of the comments

[-] argueswithidiots@lemmy.world 2 points 1 month ago

Thank you for this very detailed response. Unfortunately I can't use narrower gates, since both 8 ft gates close in the middle as this is a driveway gate.

I am absolutely planning on putting diagonal brace boards in, but since the front material is only 5/8 in thick, and the back has three horizontal boards, I didn't know the best way to put the diagonal brace boards in.

this post was submitted on 03 Oct 2024

4 points (83.3% liked)

DIY

1114 readers

1 users here now

For DIY - this is also a placeholder.

founded 1 year ago

MODERATORS

Hareuhal@lemmy.world