73

Includes a little jig off the side to bend the leads regularly, and holds the LEDs in consistent orientation using the cathode cutaway on the rim.

Designed by my lovely wife.

btw It is food safe to drink coffee next to 3d printed parts nerds ;)

P.S. this filament is awful, filamentium pla. The worst thing I've used since early reprap days when variability was high.

Any ideas what's causing that "shadowing" between the holes? those parts printed last I think but at the same speed/ironing pattern etc as the more matte parts between.

top 6 comments
sorted by: hot top controversial new old
[-] moody@lemmings.world 5 points 11 months ago

The "shadowing" is due to how it fills in the layers. The darker parts are done after the lighter parts, because it can't fill it all in one continuous line. Without the holes, it would just do one continuous line and it would look more even.

[-] naevaTheRat@lemmy.dbzer0.com 1 points 11 months ago

Obvs but why the different finish? It should be the same temp and feed rate. It's weirding me out and I don't have the ability to image the surface to see the specific difference.

[-] faebudo@infosec.pub 3 points 11 months ago

Lower speed between the holes because of low acceleration. Because of this more heat is brought into the layer which makes it more shiny. Your nozzle doesn't reach the same speed on a 20mm line as it does on a 200mm line.

[-] naevaTheRat@lemmy.dbzer0.com 1 points 11 months ago

Nah it's moving at the same speed, you don't see that finish at the edges of the non hole bits where it slowed to turn around.

Has to be a different cause.

[-] rambos@lemm.ee 1 points 11 months ago

You can try monotonic order for top/bottom. Not sure how it works with this many holes, but it usually works amazing for flat surface

[-] rambos@lemm.ee 1 points 11 months ago

To answer your question, imagine painting wall where you skip some parts and come back later. You can use the same speed and amount of paint, but the lines will be visible

this post was submitted on 30 Dec 2023
73 points (97.4% liked)

3DPrinting

15655 readers
58 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: !functionalprint@kbin.social or !functionalprint@fedia.io

There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml

Rules

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago
MODERATORS