1
Logitech K480 phone stand (midwest.social)
submitted 1 year ago by thegreekgeek@midwest.social to c/functionalprint@kbin.social
1 comments fedilink hide all child comments

My phone with the case is just barely too big for the slot in the K480, so after a few years of saying I should do something about it I finally did! Designed in Onshape, printed on a modified CR-10v2. Would welcome any suggestions, I already have v3 ready to go to fix the slot bit, it's just a titch too big.

top 1 comments
sorted by: hot top controversial new old
[-] ShadowRam@kbin.social 1 points 1 year ago

Not much there to improve.

It's already designed well, easily printable.

Well done.

this post was submitted on 01 Sep 2023
1 points (100.0% liked)

Functional 3D Printing

3 readers
1 users here now

Welcome fellow prototypers! This communities' purpose is to help others and share functional 3D Printing related information. While other 3D Printing Communities are a good resource, sometimes too many help posts get buried under memes and fluff. This will remain technically focused and keep the fluff removed. Please help your fellow 3D Printer hobbyists as much as you can with their issues! and showcase your functional prints and how you use or created them.

founded 1 year ago