I just received an unexpected SLA printer from what I had assumed was a failed Kickstarter for the "Coolsiga FinderOne" or C1 or Classic. The manual is clearly intended for someone who has some context, but my past experience has been entirely FDM based.

I'm not claiming it's a good manual by any stretch of the imagination, nor am I confident that it will work -- but is there an "Dummies Guide to SLA Printers" I can read through to at least know what it's talking about?

Hi - Tenlog TLD3-Pro, printing with branx new Overture PLA+, printing an OpenSCAD exported STL sliced with Cura 5.7.1 (most recent as of yesterday).

I'm printing first level at 0.3mm thickness, but the print is irregularly too thick in height -- and not by a little bit, a lot. I've lowered the temperature to 190. I've physically lowered the bed to the point that the skirt didn't print, then raised it just barely back. I've reduced the flow rate to 85%, and I'm still getting the same results. I've lowered the build plate temperature, no change.

The skirt might be a tough high in spots, but I'm ending up with the first level of a prime tower that looks like this.

Any ideas? What else can I try?