4
Prints keep failing.
(lemmy.world)
I have been using my Bambu A1 mini for the last several months without major issue, but suddenly I can't get anything to print. Even a benchy detaches before finishing.
I have scrubbed the plate with a fresh sponge, soap and water. I kept my filament in a dehydrator for a couple of days, then immediately tried to print.
There is a local problem, where an illegal landfill caught fire, and it can't be put out. I smell burning rubber all the time. Could that be the cause of the print failure? What else can I do?
Any videos of when the print fails? Is it all prints or just the Benchy? Does it always fail at the same height?
From the available info, I'd guess it got knocked off the bed because the nozzle hit the curled overhang, which indicates the first layer is too high, decreasing adhesion, and the fan is not blowing enough, so the overhangs don't cool enough, which allows them to curl upwards and get in the way of the nozzle.
More info = better diagnosis.
Everything is failing. There are definitely collisions happening.
How do you reduce the thickness of the first layer?
Lower the Z offset. Not by too much, or it'll scratch the bed.
"Everything is failing" is not useful info at all. Post a video of the failure happening if you don't know how to describe it.
I disagree with it being a first layer issue otherwise it would be failing much earlier not 80% of the way through the print. If the first layer being too thick were the issue, it would also be visible or colliding with every layer below this one too and those layers appear to be fine.
Do you have other filament to test with? That would help isolate the issue to either the filament or the printer. It could be the Z axis screws need lubrication especially if you notice this issue happening at around the same height.
How many hours are on your nozzle? Ive had to swap out my nozzle on my X1C after having similar issues and they went away. Even the hardened steel nozzles wear out and allow too much flow through them which leaves extra plastic on the print that can lead to collisions.