Any videos of when the print fails? Is it all prints or just the Benchy? Does it always fail at the same height?

From the available info, I'd guess it got knocked off the bed because the nozzle hit the curled overhang, which indicates the first layer is too high, decreasing adhesion, and the fan is not blowing enough, so the overhangs don't cool enough, which allows them to curl upwards and get in the way of the nozzle.

More info = better diagnosis.

My first guess is that your temp is off, which is causing the curling you see at the top of the archways and the nozzle is catching that. You might try printing a temp tower (one with exterior overhangs, not just the bridges) to dial in your temp settings.

All of the advice here is great but that is a Bambu printer, you should run its calibration routine again I would say and see what it says it also should be able to compensate if the bed is warped if you tell it to do bed leveling (unless the A1 doesn’t do that, I think it does though).

Also, when you say collisions is the printer colliding with itself or the part? You can also run an homing routine and manually move the hotend around to see if it has issues.

Also RE the local event, is the air temp really hot where you are? You might need extra part and hotend cooling if the ambient temp is like 40C or something. I mean like tweak the slicer not put an external fan on it necessarily hah.