33

Good morning friends! I'm still fairly new to 3D printing, although I'm learning a lot more to be dangerous now. I'm printing this part, and I have cleaned and leveled the bed, as I do before every print, and usually have very few issues. This time, my first layer went down almost perfect, with the exception of the bottom right corner being a little bit tight, but as you can see in the picture, every once in a while, I get exactly one line of it not adhering on the first layer. Subsequent layers all seem to lay down perfectly fine, so I'm suspecting bed adhesion, it's just weird that it's only in one single line. Anyone ever experienced issues like this, and seen a remedy?

you are viewing a single comment's thread
view the rest of the comments
[-] Contramuffin@lemmy.world 2 points 11 months ago

Hmm... I would still guess that it's the height. Try using the auto-home, then go to move > Z axis and lower the Z to zero, then turn off the motor. If you put a sheet of paper between the nozzle and the bed, how much friction do you feel? You should be able to distinctly feel the texture of the paper, but you should still be able to move the paper around with too much force. If that's not the case, you should try lowering the Z offset and try again until you get the friction just right, consistently, without needing to make adjustments

this post was submitted on 30 Dec 2023
33 points (100.0% liked)

3DPrinting

15647 readers
78 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: !functionalprint@kbin.social or !functionalprint@fedia.io

There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml

Rules

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago
MODERATORS