33
An "almost" perfect first layer help
(lemmy.world)
Good morning friends! I'm still fairly new to 3D printing, although I'm learning a lot more to be dangerous now. I'm printing this part, and I have cleaned and leveled the bed, as I do before every print, and usually have very few issues. This time, my first layer went down almost perfect, with the exception of the bottom right corner being a little bit tight, but as you can see in the picture, every once in a while, I get exactly one line of it not adhering on the first layer. Subsequent layers all seem to lay down perfectly fine, so I'm suspecting bed adhesion, it's just weird that it's only in one single line. Anyone ever experienced issues like this, and seen a remedy?
Hmm. Even still, it looks way too high. Your outside edges and the brim look like rounded lines. They should be flat.
If you peel up that first layer, can you see between the lines at all? It should be a solid sheet of plastic, even just the first layer.