14
Cleaning engine bay/ miscellaneous crannies (lemmy.world)
submitted 9 months ago by vivavideri@lemmy.world to c/mechanicadvice@lemmy.world
4 comments fedilink hide all child comments

So, that insight we bought last September so far seems mechanically sound, but, so, so dirty. I'm not sure how best to approach it but waiting till spring because our garage is not heated and it's cold as shit up here in MT.

My biggest concern is safely removing all the little mouse poops that are literally everywhere except in the cabin. I fashioned a cardboard cone with gorilla tape to our shitty shop vac to clean out the spare tire well but I'll probably need a smaller cylinder to reach them in the engine bay and battery compartment. On top of that it seems like dirt/dust is underneath all the trim. I believe the previous owner lived off a gravel/dirt road. It's the kind of dirt that doesn't wipe away the first time, and I don't want to ruin the dash/plastic/vinyl miscellany with harsh chemicals.

Insight is mostly aluminum so I need to double check cleaning methods to avoid. I've taken dish soap+bronze/plastic brushes to the back of the wheels (also aluminum)but sandpaper has been better. Haven't touched the front of the wheels with the sandpaper as it seems to have a gloss coat of some sort on it and would prefer to have its replacement on hand before removing it.

Ideas?

you are viewing a single comment's thread
view the rest of the comments
[-] Paragone@lemmy.world 0 points 9 months ago

Shopvac 1st, with a bag, to get all the infections stuff reduced.

That is the single most-important point.

Use a strong, not anemic, one, with a small nozzle, to concentrate the suction.

The safest method, after that, would be damp rags ( washing-soda or baking-soda solution to make the water a bit more alkaline & low-surface-tension ), perhaps on a reacher.

I learned of the damp-rags method from electricians, who were getting the dust/junk out from a building's transformers ( the power to the entire building had been killed, for the operation, which is required every few years ).

That way you have no risk of getting water/cleaning-solution into places where it'd do harm ( like electrical connectors, e.g. which can then kill some of your vehicle's systems )

_ /\ _

[-] DarkNightoftheSoul@mander.xyz 1 points 9 months ago

This is largely the same advice you'd get from Chrisfix's videos. Can confirm, this works.

this post was submitted on 17 Feb 2024
14 points (93.8% liked)

Mechanic Advice

275 readers
1 users here now

This community is for getting help with vehicle or other mechanical problems.

Remember, there are no stupid questions, we want everyone to feel welcome. If you don't want to answer a question that you think is silly, then just move on and keep it to yourself.

Rules:

  1. Don't be a dick

That is all.

founded 1 year ago
MODERATORS
ikidd@lemmy.world
BallsInTheShredder@lemmy.world
Brandonb0013@lemmy.world