1643
Munches Table Quietly
(discuss.tchncs.de)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 26 Jul 2023
1643 points (97.4% liked)
Memes
47110 readers
1021 users here now
Rules:
- Be civil and nice.
- Try not to excessively repost, as a rule of thumb, wait at least 2 months to do it if you have to.
founded 5 years ago
MODERATORS
There's lots of great reasons to switch to metric. Inability to do basic fractions isn't one of them...
For the record, it would be 16/64, or, 1/4
Nope! It'd be 6mm, then B gauge (6.045mm), then 1/4" (6.350mm). And that's not including things like over/under reamers and such.
(Sorry, I've been watching too much Blondihacks lately.)
Everyone has trouble with something that's basic for someone else - we just have different skills. If these fractions are too confusing for a significant minority of people, then that's a good reason to switch from fractional to decimal.
Except In this specific case, it's about measurements for tools. Fractional is far more practical for construction than decimal for tooling.
But somehow the brother is convinced, despite the fact that they left the hardware store without the bit they needed!