96
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 10 Jun 2024
96 points (99.0% liked)
Asklemmy
43974 readers
867 users here now
A loosely moderated place to ask open-ended questions
Search asklemmy ๐
If your post meets the following criteria, it's welcome here!
- Open-ended question
- Not offensive: at this point, we do not have the bandwidth to moderate overtly political discussions. Assume best intent and be excellent to each other.
- Not regarding using or support for Lemmy: context, see the list of support communities and tools for finding communities below
- Not ad nauseam inducing: please make sure it is a question that would be new to most members
- An actual topic of discussion
Looking for support?
Looking for a community?
- Lemmyverse: community search
- sub.rehab: maps old subreddits to fediverse options, marks official as such
- !lemmy411@lemmy.ca: a community for finding communities
~Icon~ ~by~ ~@Double_A@discuss.tchncs.de~
founded 5 years ago
MODERATORS
All great suggestions. I was gifted a secondhand resin printer a while ago. I don't have any post processing stuff or anything so haven't really delved into it.
Currently I am sitting on the board of directors for a new non-profit. Been trying to get it off the ground and have done some good in the form of utility relief for families in need. Its a lot though and while I am keeping at it, its not really scratching my itch to find new purpose.
This one combines with my suggestion, too. Lost PLA casting is a thing - you bed the print in sand or similar, add sprues, vents and feeders (and maybe some sort of extra drainage to be closed up after? I haven't looked too closely into it), and melt it out instead of having to manually take the mold apart and put it back together.
Then, you can have a cast in metal or glass without having to manually build the form, and without having to use a million mold pieces to achieve any kind of hollow geometry.