18
Sovol SV06 stringing issue (discuss.tchncs.de)
submitted 4 months ago* (last edited 4 months ago) by Fisch@discuss.tchncs.de to c/3dprinting@lemmy.world

I would really appreciate it if someone could help me with this. I'm having an issue with my Sovol SV06, which is that I get a lot of stringing. I'm still fairly new to 3D printing, so I have no idea what could cause this and how I could go about fixing this. I already searched for this issue online btw but didn't really find anything helpful.

The only change I made to this printer is that I hooked up a Raspberry Pi 4 to it and installed Klipper and Octoprint. I'm also using PrusaSlicer with the config from here.

Edit: Forgot to mention I was using PLA for this print

you are viewing a single comment's thread
view the rest of the comments
[-] RacoonVegetable@reddthat.com 1 points 4 months ago* (last edited 4 months ago)

I’m not sure about your specific situation, but usually stringing can be fixed by adding filament retraction and drying the filament. You can enable retraction in your slicer. To dry your filament, heat your bed to a temperature comfortably lower than your filament’s glassing temperature, put the spool on the bed and cover it with a box, then wait a few hours. (The filament is eepy). Be careful not to set the temperature too high or you will melt the filament and it will fuse together right on the spool, ruining the entire thing.

[-] Fisch@discuss.tchncs.de 1 points 4 months ago

I already tried increasing the retraction length but it didn't help. I have it at 0.5 mm now and I read online that Sovol recommends not going above that. Someone else also recommended drying the filament, so I'm going to try that. I don't know what the glassing temperature is but it's PLA, do you know what a safe temperature would be?

[-] morbidcactus@lemmy.ca 1 points 4 months ago

It's going to depend on the brand, prusa recommends 45c I've done at 55 and while it printed fine, don't recommend that, PLA has a fairly low glass transition temp and that was right on the low end of where that starts.

[-] Fisch@discuss.tchncs.de 2 points 4 months ago

I'm gonna try it at the temperature and time prusa recommends then

this post was submitted on 17 Jul 2024
18 points (90.9% liked)

3DPrinting

15666 readers
83 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: !functionalprint@kbin.social or !functionalprint@fedia.io

There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml

Rules

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago
MODERATORS