35

elmofire

It's got twice the capacity of the stock battery though! soypoint-1

top 4 comments
sorted by: hot top controversial new old
[-] Dirt_Owl@hexbear.net 7 points 11 months ago

Its definitely going to explode capitalist-laugh

[-] RyanGosling@hexbear.net 6 points 11 months ago

Ok I seriously need help understanding electricity and batteries.

What is the difference between wattage, voltage, current, amps, mA, and volts and how do they relate in the context of a battery?

If I charge a device, do I need to match the electricity numbers on the charger with the device or the battery?

From what I’ve read, you need to match the voltage, and everything else is fine with whatever.

[-] FuckyWucky@hexbear.net 5 points 11 months ago* (last edited 11 months ago)

watt hour is the best way imo to measure energy stored. so a 100wh battery can deliver 100watts for an hour. its why airlines restrict batteries by wh (100wh) instead of mAh

mA is the current and it varies depending on voltage of the battery. for example a 1000 mAh battery at 5V is 5Wh of energy while 1000mAh battery at 10V is 10Wh of energy.

its the reason why you can compare phone's battery capacity in mAh because all phone batteries have the same voltage (usually) 4.2V

If I charge a device, do I need to match the electricity numbers on the charger with the device or the battery?

yes you need to look for the voltage and wattage. voltage too high/low can fry the device. wattage is important too for example if a laptop is consuming 100watts of power and you have a 60w charger plugged in, itll slowly drain the battery instead of charging it.

[-] Vingst@hexbear.net 3 points 11 months ago* (last edited 11 months ago)

wattage is the product of current (measured in amps) multiplied by voltage (measured in volts),

wattage is power, energy expended over a period of time, 1 watt is 1 joule/sec

mAh (milliamperehours) and Wh (watthours) are a measure of the energy capacity of a battery, how much total juice a battery can hold when fully charged

I think you are correct about chargers. You probably want the charger to be capable of more power than the device needs. Also look out for this, https://upload.wikimedia.org/wikipedia/commons/6/68/AC_adaptor_polarity.png because I've blown up circuit boards by getting the polarity wrong.

also, voltage is roughly constant with electronics and the current is what changes when more or less power is used.

this post was submitted on 05 Dec 2023
35 points (100.0% liked)

chapotraphouse

13545 readers
899 users here now

Banned? DM Wmill to appeal.

No anti-nautilism posts. See: Eco-fascism Primer

Gossip posts go in c/gossip. Don't post low-hanging fruit here after it gets removed from c/gossip

founded 3 years ago
MODERATORS