You can double up the handles, which also spreads the load a bit so they don’t cut into your hand as much. It is mainly for compactness and easy marketing

Guaranteed to last a lifetime, for sure!

It might be an issue with concentricity. If the nozzle is not perfectly centered it creates a step that the filament can snag on. It can then cause the already softened filament to bunch up during deretraction forming a plug in the heat break. I had this issue with cheap nozzles. Everything starts fine and after a few layers it all stops for apparently no reason. Cranking up the heat makes it better for a bit, before making it worse

Witty one-liner

Gorgeous! That was an immediate buy. Any tips on where to get a nice frame?

Earmoofs

All constables are guinea pigs

Almost perfect! Of course Akansas should be Nebrahoma. Rookie mistake, but great work otherwise! Gold star

I hate it too. It should be life/work balance. Life comes first. Work to live, not live to work

Reality surpasses satire https://youtu.be/s_4J4uor3JE?si=fw-xF5aNjKzyXe99

Good bot Link updated

Brave sir Robin ran away https://piped.video/l8IkbCeZ9to