Just curious, when making this how much tolerance did you account for? I want to make some for baseball teams, but wasn't sure how much to add.

What type of material are you printing? Could be the material is eating away at the brass nozzle causing you to need to adjust the z offset.

Similar results with my Ender 3 S1. Highly recommend!

Do it! I recently purchased one and love it. Feel free to ask questions if you have any.

How long did you leave the stain on before wiping it?

There are European based seed banks. Also they share a border with the Netherlands.

We make a homemade version of the canes sauce. It's just a bunch of standard condiments. Before that I had family mail me bags of it from Zaxby's (same sauce). They would sell them massive camelback like bladders full of sauce.

What do you consider performing better if emulated? Most switch games look and perform better on PC already due to upscaling. Some obviously have issues rendering though.

Run the auto level on the printer. Once it finishes it will zero out where it thinks the z is. You can then adjust it down to the correct level. Too high, stuff won't adhere to the plate. Too low, it squishes it. Just right, and you get the picture.
You can use a piece of paper as a guide or a feeler gauge if you have one. I'd imagine the steps are very similar on the s1 pro.

I appreciate the tips - I printed using the same settings you used and it turned out great! Ill get it mounted to the wall later today.

You don't even need a pi for this option. I'm running octoprint off an old android phone and it works great.

Thanks for sharing the files. I just found my skateboard from when I was younger and wanted a way to display it!