68
Advice on a CAD solution
(sopuli.xyz)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 16 Jun 2025
68 points (100.0% liked)
Linux
55371 readers
492 users here now
From Wikipedia, the free encyclopedia
Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).
Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.
Rules
- Posts must be relevant to operating systems running the Linux kernel. GNU/Linux or otherwise.
- No misinformation
- No NSFW content
- No hate speech, bigotry, etc
Related Communities
Community icon by Alpár-Etele Méder, licensed under CC BY 3.0
founded 6 years ago
MODERATORS
It's not terrible advice tbh, even just hand sketches are solid for getting ideas down, makes it easy to translate to cad. It at least helps me think things through and the like.
Get a few pencils with different leads (some harder stuff like 2-4H and an HB) and some nice paper and you're good, but really anything works, totally have a mockup of my garage on a whiteboard planning where I want to put stuff.
As for cad packages, freecad, as far as I'm aware there are some architecture workbench plugins, and there's a tech drawing workbench. Coming back to cad after a while I found it super easy to pick back up (coming from solidworks at least)